Instructions / Assembly

ManualsBrandsUnbranded ManualsCeiling FansQuantum II 52 in. Brushed Nickel Ceiling Fan with Remote Control

4UFOD52+LK+C

8.0 KGS.

17.6 LBS.

Net weight

WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.

Quantum II

This instruction contains 5 pages:

Page 1: Foreword

Page 2: Unpack and inspect parts contained

Page 3: Notes before installation and Hanging system installation

Page 4: Wire connection

Page 5: Canopy / Blade / Bottom Plate installation

Page 6: Remote & Setting

311 0124

Toll Free: 1-855-676-7247

Summary of content (7 pages)

PAGE 1
Quantum II 4UFOD52+LK+C This instruction contains 5 pages: Page 1: Foreword Page 2: Unpack and inspect parts contained Page 3: Notes before installation and Hanging system installation Page 4: Wire connection Page 5: Canopy / Blade / Bottom Plate installation Page 6: Remote & Setting Net weight 8.0 KGS. 3110124 17.6 LBS. Toll Free: 1-855-676-7247 WARNING : Read and follow these instructions carefully and be mindful of all warnings shown throughout.
PAGE 2
READ AND SAVE THESE INSTRUCTIONS WARNING : TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, PLEASE OBSERVE THE FOLLOWING : 1]. To ensure the success of the installation, be sure to read the instructions and review the diagrams thoroughly before beginning. 2]. To avoid possible electric shock, be sure electricity is turned off at the main power box before wiring. All electrical connections must be made in accordance with local codes, ordinances and/or the National Electric Code.
PAGE 3
Unpack and inspect fan carefully to be certain all contents are included.
PAGE 4
WARNING: blades should be at least 7 feet from floor Note 1: Note 2: Turn off power at breaker box to avoid possible electrical shock. Use metal outlet box suitable for fan support. Outlet box must support 35 lbs min. OFF OFF OFF 1. HANGING SYSTEM INSTALLATION 1A. Installing mounting bracket to ceiling outlet box Install mounting bracket to outlet box in ceiling by using screws included with the outlet box and washers from the hardware bag. Outlet Box Mounting Bracket 1B.
PAGE 5
2. WIRE CONNECTION 2A. Insert receiver into mounting bracket NOTE: Do not squeeze all the wires while inserting the receiver into the mounting bracket. Receiver Mounting Bracket 2B. Making electrical wire connection Follow diagram below and make sure that all exposed wires are secured inside wire nuts. Note: Wires from house may vary in color and may not include ground wire (green). After wiring is completed, collect wires neatly inside hanging base.
PAGE 6
3. CANOPY INSTALLATION Note: Two screws are pre-installed on mounting bracket for canopy installation. 1 Push up canopy until two screws pre-screwed on mounting bracket are engaged with two key holes on canopy. 2 Rotate canopy slightly until two pre-installed screw heads are engaged in the narrow end of key holes. 3 Tighten both screws. 1 Canopy 2 3 Screw (2) Key Hole (2) 4. BLADE INSTALLATION 4A. 1 Insert Blades into Blade slots of Rotating Band.
PAGE 7
. REMOTE & SETTING SETTING for light operation before starting fan. Within 30 seconds of turning on the power, pressing and holding the “OFF” button for 3~5 seconds sets up the communication between transmitter and receiver. If a light kit is installed, the light will blink. Now the remote control is ready for operation. D: for light kit dimming 2 O N LOW:Fan low speed HI:Fan high speed HI 1 LO W O FF OFF: For SETTING / Fan speed : Light ON/OFF, hold for Dimming.