Instructions / Assembly

854 Day Bed
- 7 -
Step 3. Assemble the Sides Hex Bolt (I)
Fig.4 Countersink
Fig.5
Ensuring that the pre-drilled holes are in the
correct position shown in Step 1, place Side
(C) flat with the extended part of the arm
facing out. Place Back Post (F-R) next to Side
(C-R) and align with hex bolt into the threaded
insert in the Side (C-R). Tighten hex bolt (I)
through the predrilled hole in the Back Post (F-
R) and thread into the threaded insert. Tighten
finger tight to assist aligning other hole. Ensure
that the counter sink in the Back Post (F-R) is
facing up Notice the correct position of the
bottom cutouts on the front and back post.
Fig 4
. Ensuring that the pre-drilled holes are in the
correct position shown in Step 1, place hex
wrench into Hex Bolt (I) and tighten fully.
Tighten the lower Hex Bolt (I) fully tight as
well. Repeat for other side. Fig 5