Safety data sheet

Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
Item no.: 821569
Material Safety Data Sheet
Page 2 of 4
Important Safety Information
WARNING:
- Do not open the battery, disassemble it or allow it to fall from a substantial height.
- Protect the battery against short-circuiting – danger of explosion!
- Protect the battery against rain, do not immerse in liquids – danger of short-circuiting
- Protect the battery against direct sunlight, heat and fire.
- Do not incinerate the battery – danger of explosion!
- Do not use defective or deformed batteries.
- Use only original Durofix chargers to charge the battery.
Hazards
- Caustic liquid may escape from damaged batteries. Avoid contact.
- Contact can cause skin irritation, burns and chemical burns.
- If liquid comes into contact with the eyes, seek medical attention.
- Avoid inhaling any vapors formed or released – caustic.
Measures
In the event of contact with released electrolyte or electrolyte vapors
- Eye contact: flush eyes for at least 15 minutes with plenty of clean water without rubbing eyes and consult a physician.
- Skin contact: wash affected areas of skin with plenty of water and soap; if irritation persists, consult a physician.
- Inhalation: provide fresh air or administer oxygen immediately and consult a physician.
- Ingestion: if electrolyte has been ingested, consult a physician immediately.
- Disposal: Wear protective gear, wipe up with absorbent textile and dispose of as hazardous waste at collection points for
hazardous waste according to national regulations.
- In case of fire: Keep clear of vapors and gases generated, take wind direction into consideration. If possible without
danger, remove batteries from the vicinity of the fire. In principle, cooling or extinguishing with water is possible, but
should only be done by trained personnel with sufficiently large quantities of water.
Storage
Insert the battery in the machine only when it is in use; always remove the battery from the machine for transport and when it is
not in use.
- Storage temperature range: -20 to +35 °C (Temperatures must not exceed +50 °C!)
- Relative humidity range: 45 to 85 %
- Optimum preservation of functionality: +10 to +20 °C (charge state 2 LEDs green)