Installation Guide

3
INSTALLING WITHOUT MOULDINGS:
Pre-drill oversized holes through lattice (drill the largest
hole that screw head will allow without  tting though)
(Fig. 1). Center each screw in oversized holes and do
not overtighten to allow for expansion and contraction of
lattice (Fig. 2).
Hang the lattice with a screw every 24". Attach sides
and bottom loosely.
DO NOT
tighten all the way (Fig. 3).
If using more than one panel, do not butt panels
together (Fig. 4).
Leave
1
⁄
1
⁄
1
4
⁄4⁄
" gap to allow for expansion and contraction
1
2
3
Fig. 1
Fig. 2
Wood
Lattice
1/4" (6,35 mm)
Fig. 3
Fig. 4