SDS

SEF 40-1 2 Cycle
Conforms to OSHA CFR 29 1910.1200 and aligns to the United Nations Globally Harmonized System
Conforms to The United Nations Regulation Globally Harmonized System
Conforms to Regulation (EU) No 453/2010
Conforms to Regulation (EC) No 1272/2008 and aligns to the United Nations Globally Harmonized System
Conforms to the Australian Preparation of Safety Data Sheets for Hazardous Chemicals under section 274 of
the Work Health and Safety Act
Page 5 of 12
Section 7 - Handling and Storage
7.1 Handling Precautions: Wash hands and exposed skin thoroughly after handling. Remove contaminated clothing
and wash before reuse. Use with adequate ventilation. Avoid ingestion and contact with eyes, skin or clothing. Keep
container tightly closed. Avoid inhalation.
7.2 Storage Requirements: Store in a tightly closed container in a cool, dry and well-ventilated area.
Section 8 - Exposure Controls / Personal Protection
8.1
Chemical Names
ACGIH- TLV
OSHA - PEL
Blend of Aliphatic and Aromatic Hydrocarbons
C-2 to C-20
20 - 300 ppm TWA
20- 300 ppm TWA
8.2.
ACGIH® = American Conference of Governmental Industrial Hygienists. TLV® = Threshold Limit Value.
OSHA = US Occupational Safety and Health Administration. PEL = Permissible Exposure Limits.
NOTE: TWA Means "TWA is the employee's average airborne exposure in any 8-hour work shift of a 40-hour work
week which shall not be exceeded.
8.3 Ventilation: Provide general or local exhaust ventilation systems to maintain airborne concentrations below
TLV/PELs Local exhaust ventilation are preferred because it prevents contaminant dispersion into the work area by
controlling it at its source.
8.4 Contaminated Equipment: Separate contaminated work clothes from street clothes and launder before reuse.
Remove this material from your shoes and clean personal protective equipment.
8.5 Personal protective equipment
8.5.1 Respiratory protection
Where risk assessment shows air-purifying respirators are appropriate use a full-face respirator with multi-purpose
combination (US) or type AXBEK (EN 14387) respirator cartridges as a backup to engineering controls. If the respirator
is the sole means of protection, use a full-face supplied air respirator. Use respirators and components tested and
approved under appropriate government standards such as NIOSH (US) or CEN (EU).
8.5.2 Hand protection
Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique to avoid skin contact
with this product. Dispose of contaminated gloves after use. Select gloves tested to the ANSI/ISEA 105-2011 or
European EN374 Standard.
Full contact: Nitrile rubber
Splash contact: Nitrile rubber
8.5.3 Eye protection
Face shield and safety glasses Use equipment for eye protection tested and approved under appropriate government
standards such as NIOSH (US) or EN 166(EU).
8.5.4 Skin and body protection
Impervious clothing, Flame retardant antistatic protective clothing, the type of protective equipment must be selected
according to the concentration and amount of the dangerous substance at the specific workplace.
8.6 Protective Clothing Pictograms