Assembly Instructions Caution: You must read this before you proceed DINING CHAIR Noble House Home Furnishings LLC Page 1 OF 6
Part List Label Picture Description QTY A Seat 1 B Wood Leg 4 Description QTY ① Bolt(M6*25mm) 9 ② Flat Washer 9 ③ Allen Key 1 ④ Base Angle 5 ⑤ Spring Washer 9 Hardware Label Picture Assembly Preparation Before Beginning Assembly: X9 X9 X9 X5 Noble House Home Furnishings LLC Page 2 OF 6
Assembly Steps OVERVIEW Seat(A) Wood Leg(B) FRONT FACING This Dining Chair has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Dining Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly. Step 1 Open the carton and place all parts on a clean, non-marring surface.
Step 2 Wood Leg(B) ⑤ ② ① ③ Seat(A) Place the Seat(A) face down, on a clean, non-marring surface. Insert the Wood Leg(B) into Seat(A), align mounting positions between the Wood Leg(B) and Seat(A), then attach the Wood Leg(B) to Seat(A) using Bolt(①) ,Spring Washer(⑤),Flat Washer(②) with Allen Key( ③) . Repeat the same step to install the remaining three Legs(B). Do not fully tighten the Bolt.
Install the base Angel(④) to the wooden leg(B) with hand as pictured above. Place the Dining Chair on a LEVEL SURFACE. Inspect it and make sure all parts are adequately connected. Gently and gracefully, sit into to the Dining chair. This will help to align all the parts at all joint areas. Then get off the Dining Chair and proceed to tighten the Bolts(①) in a sequential manner. When tightening the Bolts(①) tighten sequentially. DO NOT tighten any Bolts(①) fully and then move on towards the next one.
Noble House Home Furnishings LLC Page 6 OF 6
