Datasheet

Product Performance and Suitability
All of the descriptive information, the typical performance data, and recommendations for the use of FLEXcon products shall be used only as a guide and do not
reflect the specification or specification range for any particular property of the product. Furnishing such information is merely an attempt to assist you after you
have indicated your contemplated use and shall in no event constitute a warranty of any kind by FLEXcon. All purchasers of FLEXcon products shall be responsible
for independently determining the suitability of the material for the purpose for which it is purchased. No distributor, salesman, or representative of FLEXcon is
authorized to give any warranty, guaranty, or make any representation in addition or contrary to the above.
___________________________________________________________________________________________________________________________________________________________________________________
FLEXcon, 1 FLEXcon INDUSTRIAL PARK, SPENCER, MA 01562-2642 PHONE [phone] FAX [phone]
Providing Solutions in Pressure Sensitive Films
___________________________________________________________________________________________________________________________________________________________________________________
Product Construction Sheet
COMPUcal II® PM 200 WHITE MT/C-329 L-23 90PFW
GENERAL DESCRIPTION:
This is a matte topcoated computer printable white polyester film coated with a permanent
pressure sensitive acrylic adhesive and backed with a layflat release liner.
UL RECOGNITION:
This product is UL recognized for indoor/outdoor use with occasional exposure to lubricating oil and
water. For further information, please reference FLEXcon’s UL file No MH10170 (N) and MH16635 (N) or
contact your FLEXcon Representative.
----------------------------------------------------------------------------------------------------
PRODUCT DATA VALUE TEST METHOD
----------------------------------------------------------------------------------------------------
PHYSICAL PROPERTIES
Thickness Film: 50 +/- 10 % ASTM D 3652
(micron) Adhesive: 25-28 +/- 3
Liner: 180 +/- 10 %
Dimensional Stability (%) No shrinkage observed On Al panel at
70`C for 24 hr.
----------------------------------------------------------------------------------------------------
ADHESION PROPERTIES**
Adhesion from Average
(N/m)
Stainless Steel 726 FTM 1 (Modified for
Acrylic 737 72 hr dwell time)
Glass 682
Expected Shear 25 FTM 8
(hours)
Tack (gm/sq cm) 370 ASTM D 2979
** For guidance only
This data is based on limited test results due to the custom nature of this product, not to
be used for setting specifications.
----------------------------------------------------------------------------------------------------
EXPECTED EXTERIOR LIFE Film: Two years, Matte Coating: Turns yellow under sunlight
----------------------------------------------------------------------------------------------------
SERVICE TEMPERATURE RANGE -40`C to 150`C
----------------------------------------------------------------------------------------------------
MINIMUM APPLICATION TEMPERATURE 10`C
----------------------------------------------------------------------------------------------------
STORAGE STABILITY Two years stored at 21`C and 50% RH
----------------------------------------------------------------------------------------------------
* COMPUcal II is a registered trademark of FLEXcon Company, Inc. 08-10-2004