Datasheet

Product Performance and Suitability
All of the descriptive information, the typical performance data, and recommendations for the use of FLEXcon products shall be used only as a guide and do not
reflect the specification or specification range for any particular property of the product. Furnishing such information is merely an attempt to assist you after you
have indicated your contemplated use and shall in no event constitute a warranty of any kind by FLEXcon. All purchasers of FLEXcon products shall be responsible
for independently determining the suitability of the material for the purpose for which it is purchased. No distributor, salesman, or representative of FLEXcon is
authorized to give any warranty, guaranty, or make any representation in addition or contrary to the above.
________________________________________________________________________________________________________________________________________________________________________________________
FLEXcon, 1 FLEXcon INDUSTRIAL PARK, SPENCER, MA 01562-2642
PHONE [phone] FAX [phone]
Providing Solutions in Pressure Sensitive Films
________________________________________________________________________________________________________________________________________________________________________________________
Product Construction Sheet
BRUSHcal® MMV 600 F BBSTAINLESS TC-249 V-23 90 PFW
GENERAL DESCRIPTION:
This is a lamination of a top-coated metallized brush stainless polyester and flexible white vinyl film
coated with a permanent pressure sensitive acrylic adhesive and backed with a layflat release liner.
-----------------------------------------------------------------------------------------------------
PRODUCT DATA VALUE TEST METHOD
-----------------------------------------------------------------------------------------------------
PHYSICAL PROPERTIES
Thickness Laminate: 150 +/- 15 % ASTM D 3652
(micron) Adhesive: 30-33 +/- 3
Liner: 175 +/- 10 %
Dimensional Stability (%) MD: 0.75 On Al panel at
TD: 0.50 71`C for 24 hr.
-----------------------------------------------------------------------------------------------------
Average
Adhesion from (N/m)
Stainless Steel 726 FTM 1 (Modified for
Acrylic 737 72 hr dwell time)
Glass 682
Expected Shear 25 FTM 8
(hours)
Tack (gm/sq cm) 370 ASTM D 2979
** For guidance only
This data is based on limited test results due to the custom nature of this product, not to
be used for setting specifications.
-----------------------------------------------------------------------------------------------------
EXPECTED EXTERIOR LIFE Indoor use only
-----------------------------------------------------------------------------------------------------
SERVICE TEMPERATURE RANGE -40`C to 80`C
-----------------------------------------------------------------------------------------------------
MINIMUM APPLICATION TEMPERATURE 10`C
-----------------------------------------------------------------------------------------------------
STORAGE STABILITY Two years stored at 21`C and 50%
RH
-----------------------------------------------------------------------------------------------------
* BRUSHcal is a registered trademark of FLEXcon Company, Inc. 07-11-2007