Instructions / Assembly

Your Hayride Hellion is now fully assembled. Turn on to let the fun begin. Enjoy!

7.1

3/3

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority

to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-

tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following

measures: Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the

equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or experienced

radio/TV technician for help.

CAN ICES-3 (B)/NMB-3 (B)

ON OFF

AA 1.5V

OPERATION INSTRUCTIONS:

1. Battery replacement instructions:

3x1.5V AA batteries (Not Included).

You will need a screw driver (Not Included).

Remove safety screw with screw driver, slide battery cover to open, insert new batteries observing correct

polarity, replace the lid and screw. Do not over tighten screw.

2. Settings:

OFF

- This switch mode will continually turn off the lights.

- This switch mode will continually operate the lights.

Distributed by Home Depot

2455 Paces Ferry Road Atlanta, GA 30339

1-877-527-0313