User manual

00092714, Version 1.4
14/20
INSTALLATION
Installing/Replacing the lamp
DANGERTOLIFE!
Onlyinstallthelampwiththedeviceswitchedoff!
Unplugfrommainsbefore!
Thelamphastobereplacedwhenitisdamaged
ordeformedduetotheheat!
CAUTION!
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
During the operation, the lamp reaches temperatures of up to 80° C.
Do only replace the lamp with appropritate UV-tubes.
UV illuminants are hazardous waste which needs to be disposed of appropriately.
Please dispose of the unusable UV illuminants in accordance with the current legal regulations.
Procedure:
Step 1: If replacing the UV-tube lamp, remove the old lamp from the socket.
Step 2: Insert the new UV-tube lamp into the lamp-socket.
Rigging
DANGEROFFIRE!
Wheninstallingthedevice,makesurethereisnohighly-inflammable
material(decorationarticles,etc.)withinadistanceofmin.0.5m.
The device can be installed on the ground or on the wall or ceiling.
Hanging installation
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.