Datasheet

JACKCON Electrolytic Capacitors
CONTENTS OF QUALITY ASSURANCE
SCOPE ASSURANCE METHOD CONTENTS
Performance
Unless otherwise specified, the capacitors shall be measured at +15℃ to +35℃ , 45to75%RH. However, if any
Doubt arises on the judgment, the measurement conditions shall be +20±1℃, 60to70%RH the test
Conditions shall comply with IEC-60384-4.
1. Capacitance(CAP.)
Measuring frequency :120Hz±20%
Measuring voltage :0.5V rms. +1.5 to 2.0V dc
Measuring circuit :Series equivalent circuit.
Criteria: Shall be within the specified capacitance tolerance.
2.Dissipation Factor (tanδ)
Measuring frequency :120Hz±20%
Measuring voltage :0.5V rms. +1.5 to 2.0V dc
Measuring circuit :Series equivalent circuit.
Criteria: Shall not exceed the specified in the table of Ratings.
3. Leakage Current (L.C.)
DC leakage current shall be measure with rate voltage, which is applied through a
resistor of 1,000±10Ω connected in series with the capacitors , at the end of a
specified period after the capacitors reached the rated voltage across the terminals.
Criteria: Shall not exceed the specified in the table of Ratings.
4. Surge Voltage
4.1 The surge DC rating is the maximum voltage to which the capacitor should be subjected under
any conditions. This includes transients and peak ripple at the highest line voltage.
4.2 Capacitors, connected in series with 1000 ohm resistors, shall withstand the surge test
voltage applied at the rated of 1/2 minute on, 4 1/2 minutes off, for 1000 successive
test cycles at 20°C (see the following table)
PERFORMANCE CHARACTERISTICS(continued)
Rated Voltage (WV) 6.3 10 16 25 35 50 63 100 160 200 250 350 400 450
Surge Voltage (SV) 10 13 20 32 44 63 79 125 200 250 300 400 450 500
Criteria: Capacitance change :≦±15% of initial value
Dissipation Factor :within specified value
Leakage Current :within specified value
Physical :no broken and undamaged
P.1 FM0754B-4