Datasheet

ManualsBrandsUnbranded ManualsCapacitorsElectrolytic capacitor Axial lead 22 µF 16 Vdc 20 % (Ø x L) 6 mm x 13 mm 1 pc(s)

JACKCON Electrolytic Capacitors

105℃ LAKSERIES

● 規格書

Item Performance Characteristics

Operating Temperature Range(℃)

-40+105℃ 10 to 100VDC -25+105℃ 160 to 450VDC

Capacitance Tolerance (%)

±20%

Rated Voltage Range(v) 10 16 25 35 50 63 100 160 200 250 350 400 450

Dissipation Factor(tanδ%)max.

20 17 15 12 10 10 10 20 20 20 20 24 24

Leakage Current (LC.)

(μA /after 5 min.)max.

I≦0.02 CV or 3(uA) After 5 minute

whichever is greater measured

With rated working voltage applied

I≦0.03 CV or 4(uA) After 5 minute

With rated working voltage applied

ΔC/C Within ±20％ of the initial value

Tanδ ≦200% of the initial specified value

Life Test：

Load Life Test：

After 1000 Hrs at 105℃

Shelf Life Test：

After 500 Hrs at 105℃

LC.

Load：≦The initial specified value

Shelf：≦200% specified value

Detail specifications

Conform to IEC 60384-4

Spec. & RIPPLE CURRENT:

uF WV SIZE Maximum Ripple Current

22 16 6X13

48mA,rms,120Hz at 105℃

Dimensions

￠Ｄ

5 6 8 10 13 16 18 20 22 25

￠ｄ

0.6 0.6 0.6 0.6 0.6 0.8 0.8 0.8 0.8 0.8

Multiplier for Ripple Current VS, Frequency

CAP(uF)Hz 50(60) 120 500 1K 10K

Under 100 0.70 1.00 1.30 1.40 1.50

100＜CAP≦1000

0.75 1.00 1.20 1.30 1.35

Multiplier

1000 up above 0.80 1.00 1.10 1.12 1.15

Summary of content (8 pages)

PAGE 1
JACKCON Electrolytic Capacitors 105℃ LAKSERIES ● 規格書 Item Operating Temperature Range(℃) Performance Characteristics -40+105℃ 10 to 100VDC -25+105℃ 160 to 450VDC Capacitance Tolerance (%) ±20% Rated Voltage Range(v) Dissipation Factor(tanδ%)max. 10 16 25 35 50 63 100 160 200 250 350 400 450 20 17 15 12 10 10 I≦0.02 CV or 3(uA) After 5 minute whichever is greater measured With rated working voltage applied Leakage Current (LC.) (μA /after 5 min.)max.
PAGE 2
JACKCON Electrolytic Capacitors CONTENTS OF QUALITY ASSURANCE SCOPE Performance ASSURANCE METHOD CONTENTS Unless otherwise specified, the capacitors shall be measured at +15℃ to +35℃ , 45to75%RH. However, if any Doubt arises on the judgment, the measurement conditions shall be +20±1℃, 60to70%RH the test Conditions shall comply with IEC-60384-4. 1. Capacitance(CAP.) Measuring frequency Criteria: :120Hz±20% Measuring voltage :0.5V rms. +1.5 to 2.0V dc Measuring circuit :Series equivalent circuit.
PAGE 3
JACKCON Electrolytic Capacitors Endurance characteristic NO. 5 Item High temperature load life test Condition 1. 2. 3. 4. 6. 7. 8.
PAGE 4
JACKCON Electrolytic Capacitors 9. 10. 11. Low temperature test Vibration test Reflow test Capacitor are place at -40±3℃ for 72± 4hrs.And then the capacitor shall be subjected to standard atmospheric conditions for 16 hours, after witch measurements shall be made. Capacitance change TANδ Within ±10% of the initial value Within specified value Leakage Current Physical Within specified value no broken and undamaged Fix it at the point 4mm or less form body. For ones of 12.
PAGE 5
JACKCON Electrolytic Capacitors 12. Solderability test After the lead wire fully immersed in the solder for 2±0.1 sec at a temperature of 245±2℃, the solder coating must be more then 95% 13. Mechanical 1. 2. The test is about lead tabs strength. Tension test: The lead tabs shall not be broken or any malformed condition after fixing capacitor vertically and pressing the following weight on the lead tabs of capacitor for 10±1 sec. Lead tabs diameter(mm) Weight(Kg) 0.5 ≦0.5 0.6~0.8 1.0 >0.8 2.5 3.
PAGE 6
JACKCON Electrolytic Capacitors CODE CONSTRUCTION LAK 220 M 16 V 6 Series (1) Capacitance (2) Tol. (3) Voltage Sleeve (4) (5) Dia. (6) 13 ---- Length (7) Forming (8) (1) Series: LGK LHK LMK LSM LEK LPS LKP LNP LLK LBP (2) Capacitance (uF): μF Code μF Code μF Code μF Code 0.1 0R1 0.22 R22 0.33 R33 0.47 R47 1 010 2.2 2R2 3.3 3R3 4.7 4R7 10 100 22 220 33 330 47 470 100 101 220 221 330 331 470 471 1000 102 2200 222 3300 332 4700 472 10000 103 22000 223 33000 333 47000 473 1.
PAGE 7
JACKCON Electrolytic Capacitors ＬＡＢＥＬ FRONT JACKCON Electrolytic Capacitor Capacitance Range: 22 uF Voltage Range: 16 V Quantity: Remark:6*13 1000 105℃ MADE IN TAIWAN pcs RoHS COMPLIANT Lot No：8 070313-000314 DATE P.6 LOT NO.
PAGE 8
JACKCON Electrolytic Capacitors Marking FRONT JACKCON 22uF16V -40+105℃ BACK 02 (PRODUCTION LINE) 10D (DATE CODE) LAK P.