PROFESSIONAL ASSEMBLY, CARE AND USE INSTRUCTIONS READ CAREFULLY IMPORTANT: This appliance is for Household use only. This is not a commercial appliance. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE Ardor Gas Grill w/Cart Models: 43110, 43111 & 43112 Questions, problems, missing parts? Before returning to your retailer, call our customer service department at: 1-800-321-3473 8:00 AM - 5:00 PM (EST) English Only, or Email CustomerService@landmann-usa.
Table of Contents Care and Maintenance ............................................. 30 Important Safety Information ................................... 2 Liquid Propane (LP) Safety Information.................... 5 Package Contents .................................................... 6 Preparation ...............................................................12 Assembly Instructions ............................................. 13 20 LB Gas Cylinder Installation ...............................
Important Safety Information • This grill SHOULD NOT be located under any overhead unprotected combustible construction. Always allow at least 36" from the top, bottom, back and 36" from the sides of the grill (see below). m • Storage of an outdoor cooking gas appliance indoors is permissible only if the cylinder is disconnected and removed from the outdoor cooking gas appliance. • When the grill is not in use, make sure the gas is turned • OFF at the supply cylinder.
Important Safety Information State of California Proposition 65 Warnings The LP gas supply cylinder to be used must be constructed and marked in accordance with the Specification for LP Gas Cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-b339 (Cylinders, Spheres, and Tubes for transportation of Dangerous Goods). This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Liquid Propane (LP) Safety Information Please review the below guidelines and safety information when using Liquid Propane (LP) gas. General Information • This grill is designed to be used with a standard 20 lb. LP gas cylinder. • Any brand of 20 lb. LP gas cylinder is acceptable for use on this grill, provided that it is compatible with the grill’s retention means (tank tray bolt). • This grill is designed certified by ETL international for local LP gas supply.
Package Contents Model: 43110 6
Package Contents Model: 43110 Part Quantity A Rubber B 3B Grill Assembly C D Shelf Bracket Right E Shelf Bracket Left F 3B Cart Back Panel G Cart Right Panel k H I k J 3B Cart Right Door Caster w/out Lock 3B Cart Left Door 3B Cart Front Brace 3B Cart Cart Left Panel 3B Cart Brace 3B Drip Tray 2 Flamer Tamer 3B Z 3B 7 3
Package Contents Model: 43111 8
Package Contents Model: 43111 Part Quantity A Rubber B 4B Grill Assembly C D Shelf Bracket Right E Shelf Bracket Left F G Cart Right Panel k H I k J Caster w/out Lock Cart Left Panel 4B Cart Brace Flamer Tamer Z 9
Package Contents Model: 43112 10
Package Contents Model: 43112 Part Quantity A Rubber B 5B Grill Assembly C D Shelf Bracket Right E Shelf Bracket Left F G 5B Cart Cart Right Panel k H k I J 5B Cart Right Door Caster w/out Lock 5B Cart Left Door 5B Cart Front Brace 5B Cart Cart Left Panel 5B Cart Brace 4 Flamer Tamer 5B Z 5B 11 5
Preparation Before beginning assembly of this grill, make sure all parts are present (see Package Contents on previous pages). If any part is missing or damaged, DO NOT attempt to assemble the product.
Assembly Instructions 1. Parts needed - M, R AA BB M CC R 2.
Assembly Instructions 3. Part needed - H, I H I HH 4.
Assembly Instructions 5. Part needed - F F EE FF GG 6.
Assembly Instructions 7. Parts needed - Q GG FF EE Q 8.
Assembly Instructions 9. Parts needed - D, E D EE FF GG E 10 Parts needed - J, L, O, P Four pieces screws (DD) for assembling Door Handle (O) are pre-attached to the Door Handle.
Assembly Instructions 11 12 Parts needed - A, C, U Rigtht & Left side shelf are assembled by the same procedure as below.
Assembly Instructions 13 D 14 Parts needed - B B 19
Assembly Instructions 15 II 16 20
Assembly Instructions 17 Parts needed - W Lower Pin W W Lower Pin 18 Parts needed - X, Y, Z Z Flame viewing hole Y X 21 W
Assembly Instructions 19 Parts needed - A A 20 Parts needed - K K 22
Assembly Instructions 21 Parts needed - V V 23
20LB Gas Cylinder Installation 3 1 4 2 IMPORTANT NOTE: LP Gas Cylinder not included.
Connecting Gas Cylinder 1. ALWAYS place the propane cylinder on the tank holder under the cart. 2. ALWAYS confirm that all burner control knobs are in the OFF position before activating the gas supply. 3. Before connection, be sure that there is no debris caught in the head of the gas cylinder, head of the regulator valve, or in the head of the burner and burner ports. 4.
Main burner Lighting Instructions Prior to the first use, it is important to clean your grill with heat. This will clean the internal parts by burning off any residue and odor from the manufacturing process. To perform this cleaning, operate the grill for approximately 15-20 minutes at the highest heat setting with the lid closed. Match Lighting IMPORTANT Please read these instructions before attempting to light the grill.
IMPORTANT Please read these instructions before attempting to light the grill. Failure to open the lid before igniting may result in an explosive flare-up, which can cause serious bodily injury or death. cooking without grease dripping on the hot DO NOT lean over the open grill when lighting. compatible rotisserie kit accessory which is 1. 2. 3. 4. Turn all gas control knobs to the OFF position. Turn on gas valve from gas source. Lid MUST be open when lighting. Remove warming rack. 5.
Using the Rotisserie Burner Match Lighting Note: Match lighting tool is located on the inside of the door. 1. Turn all gas control knobs to the OFF position. 2. Lid MUST be open when lighting. 3. Remove warming rack. 4. Remove the match lighting tool and stick a match into the end of the tool. 5. Light the match. 6. Once lit, guide the lit match to the front of the infrared rotisserie burner. 7. Push in and turn the rotisserie bunrer control knob to HI. 8.
Cooking Methods And Grilling Tips Direct Heat Direct heat cooking means that the food is placed on grill grates directly over the lighted burners. • The lid position can be either up or down. • If the lid is in the up position, generally cooking time may be longer. • Direct heat is used to sear the food to seal in the natural juices by cooking with intense heat for a short period of time. The outside of the food is browned with a flavorful grilled coating.
Care and Maintenance Please use the following guidelines to keep your grill clean and looking new. Before any cleaning, make sure all the burners are in the OFF position and grill is cool to the touch. Checking the Flame The flame coming out of the burners should be a blue/yellow combination and between one to two and a half inches tall (see below). Cleaning the Outside of the Grill For the stainless steel surfaces, use a good quality stainless steel cleaner.
Maintenance & Cleaning Maintenance • Always use the mildest cleaning solution first, scrubbing in the direction of the grain. Specks of grease may gather in the grain of the stainless steel and bake on to the surface, giving the appearance of rust. Landmann products are known for their attractive appearance.
Maintenance & Cleaning THE LANDMANN LIMITED LIFETIME WARRANTY PROVIDES PROTECTION AGAINST RUST THROUGH OF PARTS THAT RENDER THE PRODUCT INOPERATIVE. IT DOES NOT COVER OCCASIONAL SURFACE RUST OR STAINING DUE TO ENVIRONMENTAL CONDITIONS. After your first use certain areas of the grill may discolor from the intense heat given off by the burners - this is normal and cannot be cleaned off. For light and heavy food stains there are many different stainless steel cleaners available.
Troubleshooting Problem Cause Solution Grill will not light. 1. LP cylinder valve is closed. 2. LP cylinder gas level is low. 1. Turn ON LP cylinder valve. 2. Replace LP cylinder. 3. “Match lighting” may be necessary. 3. “Match lighting” light grill per this manual’s instructions. 4. Connections to the igniter are loose. 5. Electrodes may be wet. 6. Debris is blocking the electrodes. 7. No spark shows at igniter tip. 8.
Grilling Guidelines Type Description Cooking Burner Method setting Thickness Total time Instructions BEEF Steaks NY Strip, Rib eye, Porterhouse, T-Bone, Sirloin, Filets Direct High 1 in / 2.5 cm 10-15 min Turn meat only once, halfway through the grilling time NY Strip, Rib eye, Porterhouse, T-Bone, Sirloin, Filets Direct High 2 in / 5 cm 18-22 min Turn meat only once, halfway through the grilling time Flank (per lb / kg) Direct Medium .75 in / 1.
Grilling Guidelines Cooking Burner Method setting Thickness Total time Instructions Type Description Shrimp 18-20 oz / 510-566 g Direct High 3-6 min In Husk Direct Medium 20-30 min Husked Direct Medium 12-15 min Baking, whole Direct High 45-90 min Individually wrapped in aluminum foil. Rotating occasionally Sweet, whole Direct Medium 40-70 min Individually wrapped in aluminum foil.
Replacement Parts Model: 43110 36
Replacement Parts Model: 43110 37
Replacement Parts Model: 43110 38
Replacement Parts Model: 43111 39
Replacement Parts Model: 43111 40
Replacement Parts Model: 43111 41
Replacement Parts Model: 43112 42
Replacement Parts Model: 43112 43
Replacement Parts Model: 43112 44
Natural Gas Conversion Installation Safety Precautions This grill is designed for natural gas use at 7 inch water column supply pressure. Verify supply pressure with your local gas company. If supply pressure is different than this, contact a certified plumber for assistance. Once appliance is converted to use with natural gas (NG), do not use with LP gas. Grill installation must conform with local codes, or in their absence with National Fuel Gas Code, NFPA 54/ ANSI Z223.1.
Natural Gas Conversion ÐßÎÌÍ Ô×ÍÌñÜ×ßÙÎßÓ î Natural Gas Orifices - See diagrams on next page for your specific model ó Using pliers remove R pins from above flame crossers ó λ³±ª» Flame crossers 1 Natural Gas Hose (not inclided) 1 Orifice Removal Tool R-pin Conversion label Tools required for assembly: 7mm wrench Pliers Adjustable wrench Phillips screw driver WARNINGS & CAUTION: FOR OUTDOOR USE ONL.Y Turn off NG supply at piping when the appliance is not in use.
Natrual Gas Coversion 5 - Insert Orifice Removal Tool into Firebox Burner opening and unnscrew Orifies from ends of Valves. Save removed Orifices for later if converting back to LP Gas. This valves are designed to work with Natural Gas once Orifices are removed. Do not replace any Orifices when using Natural Gas. - Install Orifices for Natural Gas. -Be sure to use orifice size chart below to install the proper orifice on each burner.
Natrual Gas Coversion 6 For models 43111 & 43112 only - Use Phillips head screw driver to remove cover from back panel - Remove Infrared Orifice with 7mm wrench - Install Orifice for Natural Gas Cover 7mm Wrench Infrared Orifice 48
Natural Gas Conversion For LP Gas For Natural Gas Convert Valves to Natural Gas: - Remove control knobs. - Using small flat head screw driver turn the minimum rate screws counterclockwise until they stop. - Reinstall control knobs. Note: The minimum rate screw setting for Natural Gas is turned all the way counterclockwise, for LP it should be turned all the way clockwise. Convert regulator to natural gas: - Use adjustable wrench to remove regulator cap.
The Natural gas hose and quick connect are not supplied with this product but are available as an accessory for purchase from your local dealer. A professionallly-installed shut-off valve between the supply piping and the socket is always recommended, but not The socket connection must always be made outdoors. resistant socket on gas as pipe dope or teflon tape. shown in Figure gas A the gas so page, shows properly connected hose and socket. never be connected to the grill. the socket.
Connecting Grill to the Natural Gas Source 5. Connect natural gas hose to the regulator inlet and tighten with an adjustable wrench. 6. Checking for Leaks a. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with three parts water. b. Make sure control knobs are in the OFF position. c. Spray some solution on all fittings, pipe connections and regulator assembly. d. Inspect the solution at the connections for bubbles. If no bubbles appear, the connection is secure. e.
Limited Warranty This Gas Grill is warranted to be free of defects in material and workmanship when properly assembled, used in a normal household setting and cared for as directed in these instructions from the date of the original retail purchase for the following durations: Lifetime - Stainless steel panels 10 years - Stainless steel burners, cooking grates and flame tamers 1 year - all other parts Rust, corrosion, scratches, discoloration or any damages due to improper use and care of this grill is excl
