Installation Guide

(E) Drill two 3/32” holes in all four rosette blocks.
(F) Center bottom left side rosette #2 on bottom fluted piece. Nail in place. Do the same for right side rosette #8.
(G) Mark left side of window 1/8” past top left corner.
(H) Measure distance from bottom left rosette #2 to mark. Cut both side pieces #3 and #7 to this length. Drill holes
in both pieces.
(I) Center both side fluted pieces on rosette blocks #2 and #8. Both pieces should run parallel to window jamb. Nail
side fluted pieces in place.