Instructions

IMPORTANT: Please read all instructions thoroughly before beginning. For final installation, always use an approved adhesive at every assembly joint.
Installation with Sleeve on Kneewall Stairway
1. Trim the bottom of the newel to the proper length. If
necessary, trim the sleeve to the desired length.
2. Slide the 4175SL Sleeve onto the bottom of the box
newel. Mark and drill two 1" diameter holes through
the front panel of the sleeve and into the newel face
to a depth of approximately 1/4".
3. In the center of each 1" hole, drill a 3/8" diameter
hole completely through the box newel and sleeve
back panel.
4. Mark and drill the appropriate pilot hole for a
5/16" x 5-1/2" lag bolt in the end of the kneewall to
correspond with the holes previously drilled through
the newel and sleeve.
5. Position the newel with sleeve against the kneewall
end. Attach with 5-1/2" lag bolts. Use glue or
construction adhesive on the final assembly.
6. Install 1" plugs and sand.
See catalog or www.creativestairparts.com for
installation hardware options that will allow you to
install the 4075 Box Newel without the 4175SL Sleeve.
Side View
Sleeve Back Panel
5-1/2"
Lag Bolts
5-1/2"
Lag Bolts
Kneewall
Top View
1" Wood
Plugs
1" Wood
Plugs
Newel
Sleeve
Kneewall
Balustrade
Centerline
4075
Box Newel
4175SL
Box Newel
Sleeve
4075 & 4175SL
combined.
Both Newel and
Sleeve can be
trimmed to desired
length
4075 Box Newel
Installation Instructions
Open Tread and Balcony Installation
NOTE: For interior use only
5