User Manual

Six-servo Robot Arm DAGU Hi-Tech Electronic Co., LTD www.arexx.com.cn
1.2, Main Board Power Connector Introduction
Road32 controller shows as Figure NO.1:
Figure NO.1
Note: See the above picture, dots mean connect to positive, squares
connect to negative.
As shows Figure No.1: Read from the top, the board has three positive
power inputs, in the middle there is a MCU power input. Using a voltage
regulator to stable at 5 V. So the voltage is between 6 V to 12 V. The both
sides supply power to Road 16 servo motor respectively. Input the voltage
between 4. 8 V ~ 6V.
4