User Manual

Six-servo Robot Arm DAGU Hi-Tech Electronic Co., LTD www.arexx.com.cn

If the "Connections" button to shows "disconnected", "Settings" button is in

failure state.

Note: Please note that not "connect" button showing the "disconnect" is

successful.

If you want to use portable computers to control the robot arm, (the majority

of portable computer does not have COM), so you need have a USB port to

the RS232 COM cable, when successfully connect to the computer, com1

and com2 are invalid, then, you can try to find the controller the COM

number display in the computer. After connecting the MCU power supply,

click "My Computer" and then click “management" menu, enter the

"Computer Management” to set up user interface (see Figure No.5), click on

the left " Device Manager "menu to start the right of” port (COM and LPT) ",

you will find a" USB COM Port (com10) ", as this example. In the "com1"

changed to "com10", click "OK" button to select "connect" button, so it

finishes the communications.

Note: the cable connecting from USB to RS232 COM can be bought from

the market, but all the chips are not useful for the cable.