Installation Guide

3
Installation
22”, 559 mm
Hole Size
Ø 5/16”, 8 mm
1) Measure and mark hole spacing
according to dimensions provided
on page 1. Drill 5/16" (8 mm) hole in
wall for mounting hardware.
2) Insert toggle anchor (S) into 5/16"
hole. Locate mounting ring (R) over
toggle anchor (S) and secure to wall
with mounting screw (Q).
3) Install water connector (C) to pipe
tting. Slide ange cover (B) onto
water connector so it sits ush with
nished wall.
1
2
3
Q
R
S
T
Note: For dry wall 1/2" thick or less,
insert anchor tool (T) into toggle
anchor (S) to secure behind wall prior
to installing trim.
2
A
1
D
N
P
U
A
4) Install shower arm (A) to shower riser
body (D). Use caution not to remove
o-rings (U) from gooves. Slide ange
cover (P) over diverter body (N).
5) Install shower riser body (D) to water
connector (C) and diverter body (N)
to mounting ring (R).
6) Secure shower riser assembly
to nshed wall by tightening set
screws (E & O). Slide ange cover
(P) so it sits ush with nished wall.
D
C
N
R
Note: Apply plumber tape to water
connector (C).
1
2
B
C
3
2
E
O
P
1