Installation Guide

S  H
Store LP TechShield panels in a clean, dry area. Do not store in
direct contact with the ground. Protect from moisture prior to and
during installation. Outside storage, if necessary, requires panels
to be covered with plastic sheets or tarpaulins with the sides
loosely covered to provide adequate air ventilation.
Handle LP TechShield panels as you would other APA rated LP
sheathing products. Be careful not to drop on corners or crush
R S I
• Placetheskid-resistantsideupwiththeAPAtrademarkstamp
facingdownandwearskid-resistantshoeswheninstallingthe
roof sheathing.
• Installwiththelongdimensionorstrengthaxisofthepanelacross
supports and with the panel continuous over two or more spans.
• Provide1/8”minimumspaceatpanelendsandedges.Useaspac-
ertool(i.e.10dboxnail)toassureaccurateandconsistentspacing.
• Panelendjointsshalloccuroverframing.Staggerendjointsin
each succeeding row.
• Provideadditionalpanelstiffnessbyinstallingpaneledgeclips
mid-spanonallun-supportededges.
• Nail6”o.c.alongsupportedpanelendsandedgesand12”o.c.at
intermediatesupports.Fastenpanels3/8”frompaneledges.Use
8dcommonnailsforpanelsupto1”thickness.Forpanelsover1”
use8dring-shankor10dcommonnails.Othercode-approvedfas-
teners may be used.
• Coverroofsheathingassoonaspossiblewithroofingfeltorshin-
gleunderlaymentforprotectionagainstexcessivemoistureprior
toroofing.Ifanyedgeswellingoccurspriortoroofunderlayment
installation,allraisedjointsshouldbesandedflat.
• Allowsheathingtoadjusttohumidityandmoistureconditions
before shingle installation.
• Removewrinklesandflattensurfaceofshingleunderlayment
before installing shingles. High performance shingle underlay-
ment is recommended for better results.
B U
LP TechShield Sheathing can be used as a radiant barrier on roofs
andgableendstoreducesolargain.Thisproductinstallslikecon-
ventional roof sheathing, requiring no additional labor.
Installation instructions
LP® TechShield® Radiant Barrier Sheathing
Recommended uniform roof live loads for APA-rated sheathing
(c)
LP TechShield with long dimension perpendicular to supports
(e)
APA-RATED SHEATHING
(c)
Panel Span Performance
Rating Category
(f)
24/0 3/8
24/16 7/16
32/16 15/32, 1/2
40/20 19/32, 5/8
48/24 23/32, 3/4
MAXIMUM SPAN (IN.)
With Edge Without Edge
Support
(a)
Support
24 20
(b)
24 24
32 28
40 32
48 36
ALLOWABLE LIVE LOADS (PSF)
(d)
Spacing of supports center-to-center (in.)
12 16 20 24 32 40 48
190 100 60 30
190 100 65 40
325 180 120 70 30
305 205 130 60 30
280 175 95 45 35
G I
InstallingLPTechShieldsheathinginthegableendswillhelp
contribute to the reduction in solar gain and the overall energy
ecient design of the attic space. As with the installation of LP
TechShield sheathing on roofs, it is important that it is installed
with the foil side facing into the attic.
©2010Louisiana-PacificCorporation.Allrightsreserved.LPandTechShieldareregisteredtrademarksofLouisiana-Pacic
Corporation.PrintedinU.S.A.NOTE:Louisiana-PacificCorporationperiodicallyupdatesandrevisesitsproductinformation.
Toverifythisversioniscurrent,call800-648-6893.12/18/10
For a copy of the warranty or for installation and
technical support visit: www.lpcorp.com/techshield
Phone: 888.820.0325
Email: customer.support@lpcorp.com
(a) Panel edge clips (one midway between each support, except two equally
spaced between supports 48 inches on center), lumber blocking or other.
(b) 24 inches for 15/32-inch and 1/2-inch panels.
(c) Includes APA-RATED SHEATHING/CEILING DECK.
(d) 10 psf dead load assumed.
(e) Applies to panels 24 inches or wider applied over two or more spans.
(f) Performance category replaces the nominal panel thickness
Insulation
Roong
LP TechShield
foil side facing down
3/4"min.
air space
paneledges.Keeppanelswellsupportedandneatlystackedto
preventwarping.Usecautiontoavoiddamagetotheradiant
barrier foil surface.
• Heavierweightand/ortexturedshinglesarerecommendedtobet-
termaskimperfectionsinroofingassembly.
NOTE:Checkwithyourlocalbuildingdepartmentbeforedecidingonaninstallationmethod.
Cal. Prop 65 Warning: Use of this product may result in exposure
to wood dust, known to the State of California to cause cancer.

Summary of content (1 pages)