Instructions / Assembly

Page 4 of 812/17/20

1. Starting at the back of the kennel, install the roof framework (I) into the top of the panel.

Repeat for the front (FIG. 7).

2. Attach the center pole (H) to the roof framework (I) using the roof panel clamps (E).

308605B uses only one center pole.

308606B uses two center poles, connected by the 4 way center pole clamp (F)

NOTE: The wing nuts should face the INSIDE of the kennel to prevent damage to the roof cover when

installed (FIG. 8). Use the two center poles, connected by the 4 way center pole clamp (F)

3. Once the roof panel clamps are in place, tighten by hand.

FIG. 8FIG. 7

FIG. 10

1. Place the panel caps (K) into the openings at the top of each panel. Push them in all the way until

ﬂush against the metal (FIG. 11).

2. Open the gate and place a panel cap at the top opening and another at the bottom opening.

FIG. 9

(E)

(G)

(F)

(E)

4. Place the roof cover (J) over the roof framework (FIG. 9).

5. Secure the roof cover to the panels using the bungee cords (G) provided (FIG. 10).

(H)

(I)

(J)

(K)

Installing the Roof Cover (J)

Inserting the Panel Caps (K)

FIG. 11