Instructions / Assembly

Page 3 of 812/17/20
Assembly (Continued)
5. Install two panel clamps (C).
NOTE: The wing nuts used on the panel clamps should face toward the OUTSIDE of the kennel, not
the INSIDE (FIG. 4).
6. One panel clamp should be located approximately 6" from the top, the other 6" from the bottom
(FIG. 5). Do not overtighten the panel clamp wing nuts and bolts until all panels are installed. This
will allow for minor adjustments before finalizing and tightening the panel clamps.
7. Stand up the next panel and install two panel clamps approximately 6" from the top and 6" from the
bottom, wing nuts facing out. Continue until all panels are installed with two panel clamps.
8. Once complete, return to the panel clamps and tighten each wing nut by hand.
FIG. 5
FIG. 4
6"
FIG. 6
Attaching the Gate Latch (D) (FIG. 6).
(C)
(D)