Instructions / Assembly

Page 2 of 807/01/20

Parts Image Description Quantity

A1 Door Frame - Fixed Side (65") 1

Door Frame - Latch Side (66.75") 1

A3 Upper & Lower Door Frame Bars 2

A4 Chain Link Mesh - Small 1

A5 Tension Rods - Short Round (62") 2

A6 Outer Door Frame - Latch Side (72") 1

G Gate Clips 10

K Metal Tie Wires 4

Assembling the Door

(G)

(A5)

(A4)

FIG. 1

FIG. 2

FIG. 3

1. Identify and lay out the parts (A1-A6) as shown.

2. Insert parts (A3) into the receiving tube pieces on part (A2). Make sure door frame is fully inserted,

then tighten the two set screws.

NOTE: Part (A2) has a 1" extended leg; make sure you position this at the bottom.

3. Attach part (A1) to the upper and lower frame (A3) bars. Make sure it is fully inserted, then tighten

the two set screws.

4. Run tension rods (A5) through the sides of the mesh (A4).

5. Hook a gate clip (G) to the center of the door frame and snap into place on the tension rod.

Secure four more clips evenly spaced, top-to-bottom. (FIG. 2).

6. Repeat on opposite side of the door.

7. Once door is fully assembled, slide onto the outer door frame (A6).

8. Lay assembled door (A) mesh-side down. Loosen set screw on bottom (FIG. 3).

9. Attach chain link fabric to door frame using two metal tie wires (K) on both the top and bottom.

For best results, attach to the middle knuckle of the chain link fabric (FIG. 1).

NOTE: Assemble the door with the parts laying ﬂat on the ground.

(G)

(K)

(A1) (A2)

(A3)

(A6)