Use and Care Manual

Part 2: Mechanical installation

NAME QTY.

Step 8: Runing part (Y Axis) Installation

NO.

Operation

Steps

Prepare

materials

BEFORE

AFTER

CODE

Tools

Check

Remind

Stepper motor Assembly (from Step1)

M3 Bolt M3*14mm

Base (from Step6)

Lead Screw assembly (from Step7)

MX3-52

Allen wrench (mm, 2mm)

Put the Lead Screw assembly into The Base, insert the end of the

Lead screw to the hole of Phenolic resin plate-B, put another end

of the screw insert into the bearing by force, which loacted in the

middle of the Phenolic resin plate-F.

At the same time,make the steSper motor assembly install on the

Phenolic resin plate-B,insert the lead screw to the coupling of motor

assembly. tighten the M3 Bolts of motor,don't forget the small VFUHZ

in the coupling.

When you finish the steps here, you should to check the Horizontal

and vertical, if you have not any professional tools, you can stand

the base, observe the Bearing mount fall dowQ smooth, if not that

you have to check the vertical of the Guide Rail.

)inish FKHFNDQGIL[the base, you can tigthen all the bolts

(remmember WKDWwe remain 20% space before)

MX3-13

MX3-52 x4Pcs

Phenolic

resin plate-B

Phenolic

resin plate-F