User manual

10/100Base-Tx Long Reach
Ethernet Extender
BNC/RJ11
User’s Manual
Introduction
This Long Reach Ethernet Extender with one
Ethernet port (on 1 RJ-45 connector) and one
VDSL port on 1 RJ-11 / BNC connector. This is a
bridge mode modem accommodating Ethernet
and VDSL technologies to extend Ethernet over
single-pair phone line by using a VDSL signal. Up
to 50/15 Mbps transition bandwidth within 350m
and up to 5Mbps for 1km long range connections
provides ultra-high performance to the pervasive
telephone line network. Its plug-n-play solution
minimum installation time & cost by allowing video
streaming and data to share the same telephone
pair without interference.
With one DIP switches configuration, the Extender
including the CO (Central Office) site and CPE
(Customer Premise Equipment) site. The long
distance support feature makes this extender be a
great and ideal solution for FTTx (Fiber to the
Building, Fiber to the Campus or Fiber to the
Home) applications. It supports high bandwidth
VDSL over existing telephone wires in the “last
mile” from the ISP / Telecom / Service provider’s
fiber mode to the buildings and customers’ home.
Key Features
 1 full-duplex VDSL links via RJ-11/BNC
connector
 Selectable CO and CPE mode
 Selectable fast and interleaved mode
 Selectable target SNR margin
 Compliant with ETSI, ITU and ANSI
standards
Front Panel (LEDs)
LED Indicator
LED
Status
Description
Duplex
On
RJ 45 port full duplex
Off
RJ 45 port half duplex
Speed
On
RJ 45 connect at 100M
off
RJ 45 connect at 10M
Link/Act
On
RJ 45 port is link
Blinking
RJ 45 port Data is
transmitting or receiving
Power
On
Power is on.
Off
Power is off.
CO
On
Work as Master at Core
center
off
Work as CPE at Edge site
Nego
/Link /Act
Blinking
Negotiation
On
Link is connected
flash Blinking
Data Active
DIP Switches Mode Configuration
DIP
1
2
3
4
On
CO
Fast
998ISDN
6dB
Off
CPE
Interleave
Symmetric
9dB
 Pin 1 CPE or CO mode selection
 Pin 2 Interleave mode or fast mode
selection
 Pin 3 Symmetric ISDN Mode or 998 ISDN
Mode selection
 Pin4 Signal Noise Rate selection for 9dB
or 6dB
Package Contents
Before you start to install this switch, please
verify your package that contains the
following items:
 Two Long Reach Ethernet Extenders
 Two Power Adaptors
 One User Manual
Note: If any of these items is found missing
or damaged, please contact your local
supplier for replacement.