User manual

- 2 - 2-C103-01A
Driver CD
2. Installation
2.1. Hardware Installation
1. Turn off desktop computer
2. Insert Host Card into an available PCIe x4 or x8 or x16 slot.
3. Connect the RJ-45 cable / plug
4. Check the Link LED in PCIe card if the cable is connected correctly
2.2. Software Installation
1. During OS boot up, Windows will display the Found New Hardware
Wizard, “Ethernet Controller”.
2. Select “Search for a suitable driver for my device (Recommended)”
and Click “Next”, and make sure the Driver CD in your CD-ROM/DVD.
3. Under “Specify a location” insure that is only checked, and click “Next”.
4. Type in X:\ (If your CD-ROM/DVD is X:\) and click “Browse”.
5. Points specify a location, example “X: \10G NIC\Windows, then click
“OK”.
6. When the wizard indicates that it found a driver for the device click
“Next”. Then click “Finish”.