Use and Care Guide

7
RECESS-MOUNT INSTALLATION INSTRUCTIONS
Lowes.com/allenandroth
Proceed to ASSEMBLY INSTRUCTIONS on page 8 to
complete assembly.
Hardware Used
1. Determine desired location for cabinet (C), making
sure to place it where the door can swing freely without
obstruction and where no electrical or plumbling
obstacles would be behind the wall. Note: The height
of the cabinet (C) should be a minimum of 3 in. above
the faucet/vanity.
2. Mark the opening size of the framing. Once the
drywall is cut, remove any framing in the rough
opening for the item, then frame the cutout opening as
illustrated.
3. Insert cabinet (C) into rough opening and make
sure it is level and plumb; use wood shims (not
included) as required. Then, secure both sides of
cabinet (C) to the studs from the inside using long
screws (GG) and washers (EE). Cover screw heads
with snap caps (DD).
Long Screw
x 4
GG
Snap Cap
Washer
x 4
x 4
DD
EE
CAUTION: This installation type is NOT applicable for solid-wall applications.
1
2
3
19-1/2 in.
22-1/5 in.
Using a reciprocating saw (not included), cut away a
rough opening of 19-1/2 in. x 22-1/5 in. x 4-1/10 in. into
the drywall.
EE
GG
DD