User manual

Instruction manual
Hand winch
1.000 kg Art.-Nr. 25.321
600 kg Art.-Nr. 25.326
User’s manual:
1. Ratchet switch—There are 3 positions for this ratchet switch: The higher position is for
pulling, the lower position is for releasing, the middle position is for both pulling and releasing
but can only be used when unloaded. When the wench is loaded, hold the crank handle
tightly if you want to change the switch position.
2. Before using, install the wench on a firm and flat surface. To install it, put the ratchet switch
on the middle position and pull the cable out until the holes on the bottom of the base are
visible. Then use at least 3 sets of 3/8’’ bolts and locking nuts, in a triangle pattern, to fix the
base on the surface. Use an extra metal or hardwood board when necessary.
3. Then install the crank handle to the axis bolt with nut.
4. Put the ratchet switch on the higher position and turn the crank handle clockwise to pull. Put
the ratchet switch on the lower position and turn the crank handle counterclockwise to
release.
Caution:
1. Never overloaded!
2. This winch is designed for pulling, not for lifting.
3. Never put your hand or anything else near the gear, rim and rolling cable. Always wear
gloves when using the winch.
4. Never try to repair or disassemble the winch when there is a problem. Ask a machinist or
specialist for help.
5. When replacing the cable, make sure that the end of the cable comes through the 4 holes on
the side of the rim, and tie a knob or weld the end tip of cable to the cable, to prevent the
cable from coming out.
6. Use grease for axis and gears before depositing for a long time.