Instructions / Assembly

ShowerMat

power lead

Factory splice embedded in mortar outside of shower

Fill-in Technique.Roll-over Turn.

Mat mesh

removed

Use hot glue to

attach wire to the oor.

Cut mat

Roll

over

Installing in front of cabinets and toilets:

Installing in shower bed:

Install mat right up to

the face of the cabinet

as shown above.

Mat can be installed under tile to

within 6" from the wax ring, and can

slightly underlay the foot of the toilet if

need be (approximately 20" from wall).

STEP 3.6

Secure the Mat to the Floor

Lay the mat down flat. Ensure it fits well and has no folds or large ripples.

Securing the mat as flat as possible will help make a smooth surface for spreading mortar.

Ensure all edges of the mat are secured to the floor using double-sided tape, hot glue, or

pneumatically applied staples. Secure as needed across the middle of the mat to ensure the

it stays flat during floor mortar application later. If staples are used, 3/8" x 1/4" chisel type

are recommended. Do not staple closer than 1/4" (7 mm) from the heating wire. Be very

careful not to damage the heating wire.