INSTALLATION INSTRUCTIONS Drop In Kitchen Sink
www.lordear.com Drop In Kitchen Sink Premium grade handmade sink. 16 gauge Stainless Steel 304. Vertical angle corner/R10 radius coved corner.The Best choice for soundproof and insulated sinks Limited lifetime warranty. In accordance with Industry Codes & Standards for USA &Canada All LORDEAR Stainless Kitchen Sinks are Certified & Listed By cUPC. CAUTION Due to the weight and sharp edges of the sink, exercise caution when handling, moving, or lifting the box or the sink.
www.lordear.com TOOLS Safety glasses / marker / silicone adhesive sealant / tape measure / Jigsaw / rags /wood braces / level / screws / bladed screwdriver Step 1：Position the Template Check the cutout template against the actual sink to make sure the cutout size is correct, then place the cutout template in the desired location on the countertop.
www.lordear.com Step 3：Cut the Countertop Carefully cut the opening in the countertop according to the tracing line (Note: use the saw suitable for cutting the material of your countertop) Step 4：Attach the mounting clip to the protruding prongs below the sink edge. Make sure the hooked side of the mounting clip is facing away from the sink.
www.lordear.com Step 6：Fix the Sink to Countertop • Insert the sink into the opening, confirm that the sink fits the countertop opening , and press firmly (Figure 4). • Tighten the screws in the front of the sink, followed by the ones in the back and on the sides of the sink (Figure 5) • Remove excess silicone-based adhesive • Allow the sealant to settle for 30-60 minutes.
www.lordear.com Step 7：Install Plumbing Fixtures • Connect the drain to the sink. Connect the trap to the drain. Connect the water supply connections to the faucet according to manufacturer’s instructions. • Drain water into the sink and check for leaks 1 2 3 4 ASSEMBLY INSTRUCTIONS 1.Cap 2.Basket 3.Bowl 4.Foam washer 5.Rubber Washer 6.Lock Nut 5 6 Drain Installation Guide 1 2 3 4 5 6 Drain Installation Guide 5 ASSEMBLY INSTRUCTIONS 1.Strainer Basket Assembly 2.Screw 3.Strainer Bowl 4.
www.lordear.com MAINTENANCE INSTRUCTIONS FAQs 1. Why is there rust in my new kitchen sink? Reasons: 1.1 Residual solder, oil, or something similar on the sink can lead to rust if not cleaned in time. 1.2 Chemical cleaning agents, paints, sauces, cooking oil, etc. can produce mold sticking to the surface after being left in the sink for a period of time. Prevention and Treatments: 1.1 Install the sink after everything else is done, and clean your sink right after installation. 1.
www.lordear.com DO 1. Clean Daily. Use a soft towel to wipe the sink with warm water. Mixing in some wash-er-fluid is advisable. Remember to wipe it dry. 2. Remember to rinse the sink after using any cleaning agent and wipe dry. If any mineral deposits are on the sink, clean it up as soon as possible. 3. Use a scrubbing pad to properly remove rust, mildew or scratches. Please wipe in the direction of the finish of the sink. 4. Rub it lightly with a soft towel in the direction of grain lines. 5.
www.lordear.com STAINLESS STEEL Topmount SINKS General Recommendations: Check all the matching products inside after opening the package. Inspect your sink for any noticeable damage before installation. Read the installation and maintenance instructions thoroughly before installation. Consult your cabinet dealer before custom order cabinet for the sink. LORDEAR suggests using experienced and professional installers.
