Instructions / Assembly

Assembly Instructions
Package Contents
Ensure the four clips on the bottom
of the fabric of the inatable (A) are
attached to the plastic legs on the
base of the intlatable.
Ensure that the air intake on the
inatable (A) unit is clear of fabric and
other obstructions and that the zipper
is fully closed. Some inatables have
more than one zipper.
Turn the inatable (A) upright and insert
four base stakes (B) through the holes
of the plastic legs into the ground.
Plug in the inatable (A) into an outlet
or other power source to inate.
Once fully inated, clip the nylon tethers
(C) to each of the attached nylon loops
on the side of the inatable (A).
Drive the stakes (D) into ground at a
45-degree angle.
A
B
1
For maximum stability bring tether down
to a 45-degree angle from the inatable
as shown in the illustration. In order to
achieve this you may need to wrap the
excess tether around the top of the stake.
2
3
4 5
7
8
A
A
A
A
B
C
A
D
45°
D
E
C
x1 x4 x4 x4 x1
Visit WWW.GEMMY.COM for more information.
©2020 GEMMY INDUSTRIES CORP.
117 WRANGLER DRIVE. SUITE 100
COPPELL, TX 75019 U.S.A.
1 [phone]
MADE IN CHINA / PRINTED IN CHINA
Using the loop at the end of the tether
(C), fasten the tehters to the tether
stakes(D).
Do’s and Don’ts
1. Do check your inatable daily and adjust
to stand up straight.
2. Do not attempt to operate your inatable
in unusually strong winds.(see caution)
3. Do not unplug by pulling on cord.
For faster deation, unzip zipper after
unplugging plug.
6
9
D
C