Installation Guide

Shower Grate Shop
www.showergrateshop.com
[e-mail]
OFFICE: [phone]
FAX: [phone]
Create a pre-slope to guide water to the outlet. The
idea is to create a slope from the outside perimeter
of the shower pan to the drain allowing any
moisture caught in the liner to flow unrestricted
out through the weep holes of the install kit.
Line the pre-slope with a waterproof membrane,
cross (X) cut holes for the three screws of the
install kit and clamp the top half of the install kit
over the waterproof membrane.
Tape all critical seams
Set your linear drain on the height adjuster and set
to finished height of tile, screw linear drain to
height adjuster.
Making sure the weep holes are not blocked
create a ¼” per foot slope towards the linear drain.
A one way fall is usually achieved. However if you
choose to install your linear drain slightly off of the
wall (shown) you will also need to slope that area
towards the linear drain.