Use and Care Manual

STEP 4:________________________________________________________________________________________

Place Bench Right Side (A) onto exposed parts and

begin with Bench Seat Bolts (D) by aligning

pre-drilled holes with inserts in Bench Seat (B).

Thread bolt in not fully tightening as before.

Repeat all previous steps inserting Bench Seat

Bolt (D) and Bench Side Bolts (F). Fig. 7

FIG. 7

STEP 5:__________________________________________________________________ ______________________

Go back through all steps and fully tighten

all Bench Seat Bolts (D) and Bench Side

Bolts (F). Ensure that all fasteners are tight

but do not over tighten and strip out

the insert. Fig. 8

FIG. 8