Instructions / Assembly

STEP 3: _________________________________________________________________________________________

With the Seat Screws provided, thread the screw into

the pre-drilled hole and into the bottom of the seat.

Hand tighten the screw until it is flush into the spindle

and into the pre-drilled counter sink. Repeat for all

four screws. Figure 9.

FIG. 9

STEP 3:____________________________________________________ _____________ _______________________

With the Buttons provided, gently tap in over the

Side Screws that were previously inserted. Ensure

that all screws are tight prior to this step. Once the

button is placed in the hole, it is very difficult to

remove the button without damaging it. Repeat for

all 10 Side Screws. Figure 10

This completes the assembly of this Rocker.

FIG.10