Instructions / Assembly

STEP 3: _________________________________________________________________________________________

Place Runner (D) onto the tenons at the bottom of the Chair Side. Once

the Runner (D) is started onto the tenons gently tap the bottom of the

runner until fully seated onto the tenon. Ensure that the pre-drilled

holes face to the inside. Repeat for the other side. Figure 7.

FIG. 7 D

STEP 3:____________________________________________________ _____________ _______________________

With the nails that are provided, start with the side that is on the ground, insert the nail into the pre-drilled hole and begin to tap

in with a hammer. Tap in until flush with the side of the runner. Repeat for all four posts.

Figure 8.

FIG.8 Nails