Instructions / Assembly

STEP 2:________________________________________________________________________________________

Lay Chair Side (G-R) over corresponding spindles and components as shown in Figure 6. This step is much easier if two people

align the corresponding spindles and components. Once the alignment is complete begin pressing down on the side to fully

seat into all of the mortises and holes. A rubber mallet or a hammer with a heavy cloth to protect the finish may be used to tap

all components in place. Figure 5

FIG. 5 G-R

STEP 2:__________________________________________________________________ ______________________

Start at the bottom back post and begin inserting the provided Side

screws. With the Hex Wrench that is provided begin to tighten

clockwise by turning the wrench. If the screw is not threading into

the Spindle or component, remove the Hex Wrench and gently tap

with a hammer and repeat the process. Be careful not to over

tighten as this will strip out the spindle or component. Once all five

are inserted on the right side, carefully flip the chair over on the

other side and repeat the entire process. Figure 6.

FIG. 6