Use and Care Manual

ROLL CASTORS
DRAIN BUCKET
MOIST AIR
INTAKE
HANDLE
CONTROL PANEL
CONTINUOUS
DRAINAGE OUTLET
DRY AIR VENT
AIR FILTER
-5-
DESCRIPTION OF COMPONENTS
Located in bucket for
installation.
Located
behind grille.
1. Remove the casto
rs from the bucket of the dehumidifier.
2. Position the dehumidifier on its side.
3. Locate the arrow on the bottom of the dehumidifier and insert the castor
according in the direction of the arrow.
4. Slide the castor in as far as it will go. The castor will snap into place
once secure.
5. Repeat steps 1 through 4 for the remaining 3 castors.
6. To remove castor, press tab down and slide the castor out.
*NOTE: Wait 24 hours before running unit.
CASTOR INSTALLATION
Castor installation is recommended to avoid damage to floors. Model
Numbers 1PED50 and 1PED70 have castors already installed.
However, Model Numbers 1PED30 and 1PED50S require castors to
be installed after unpacking the unit using the instructions below.
Castors for the 1PED30 and 1PED50S Models can be found in the
bucket when unpacking the unit for the first time.