Use and Care Manual

Direct Drain

Hose

Washer

It is highly suggested that the manual be read in full before operating the

unit. However, the notes below are especially important in helping you to

properly set up and begin to use your dehumidfiier.

DO NOT REMOVE this foam piece.

The accessories are located in the packaging as follows:

4x Castors

• Found in bucket for Model Numbers

1PED30 & 1PED50S

• Castors are already installed on

Model Numbers 1PED50 & 1PED70

Electrical waste products should not be disposed of with household waste.

Please recycle where facilities exist. Check with your local authority or retailer

for recycling advice.

5. For Model Numbers 1PED50 and 1PED70, when unpacking the dehumidifier,

note that the foam inside the float of the bucket should NOT be removed.

Without this foam piece, the dehumidifier will not operate properly.

(Model Numbers 1PED30 and 1PED50S do not require this foam piece.)

(1PED50 and 1PED70 models only.)

The dehumidifier should be kept upright. If for any reason it has not been

stored upright while in your possession, set the unit in the upright position

for a minimum of 24 hours before initial start.

Press the POWER button to turn the dehumidifier ON.

Using the + and – buttons, set the humidity to 30%RH for the first 24 hours

of operation.

After the 24 hours, set the desired humidity using the + and – buttons.

Recommended humidity is between 45~55%RH.