User manual

The following combinations result for the option value in commands 4 and 5:

Option Execution of broadcasts Blocking of broadcasts

0no no

1 (default setting) yes no

2 no yes

3 yes yes

Commands 6 and 7 – Activating/deactivating individual relays

The relays addressed in the data byte are activated/deactivated directly without changes to the

remaining outputs.

Command 8 – Toggle

The switching command only has an effect on the relays addressed in the data byte.

This command refers to the 8 relays of the board: Bit 0 in the data value corresponds to relay

K1 (clamp X1), bit 1 with relay K2 (clamp X2) etc.

E.g. relay K7, relay K6 and relay K4 are activated (01101000). If relay K6 is supposed to be

deactivated and relay K5 activated, you have to send 48 (binary 00110000) with data.