Technical Specifications

Data sheets are subject to change without notice. For the latest version, please check the product page at www.tccmaterials.com
AKONA
®
FOUNDATION COATING CEMENT
Page 2
irregularities in the surface may not be able to be corrected
with a thin surface coating.
5. Protect the surface from use until mortar is completely hard
and set. Foundation Coating Cement will harden to a tough,
durable gray finish.
Curing
Product will harden within a few hours. Wait until the product
fully cures before painting. Allow a minimum of 7 days for
product to cure when temperatures are between 65°-75°F
(18°-24°C) with no rain. Use a high-quality, exterior masonry
grade, breathable acrylic latex paint. Prime the surface prior to
applying paints.
Clean Up
Use soapy water to clean hands and tools immediately after
use. Dried material must be mechanically removed. Use a
waste water hardener (e.g. Congelz
®
or similar product) for
cementitious waste disposal.
Limitations
• Follow all industry standard safety procedures when
handling, such as gloves and eye protection. Wear gloves at
all times, failure to do so can result in severe burns.
• Do not add any materials other than clean potable water.
• This product is not designed for application directly over
plywood, vinyl, or metal.
• Temperature and humidity may cause the set time to vary
slightly. Cooler weather will slightly retard set time – hot
weather will slightly accelerate set time.
Safety
READ THE SAFETY DATA SHEET (SDS) BEFORE USING
THIS PRODUCT. SDS information is available on our website:
tccmaterials.com
Cautions
Read complete cautionary information printed on product
container prior to use.
This Product Data Sheet has been prepared in good faith on
the basis of information available at the time of publication. It is
intended to provide users with information about and guidelines
for the proper use and application of the covered Akona brand
product(s) under normal environmental and working conditions.
Because each project is different, TCC Materials cannot be
responsible for the consequences of variations in such
conditions, or for unforeseen conditions.
6. AVAILABILITY
To locate Akona products in your area, please contact:
Phone: [phone]
Website: tccmaterials.com
7. WARRANTY
Seller warrants that its product will conform to and perform in
accordance with the product specifications. The foregoing
warranty is in lieu of all other warranties, expressed or implied,
including, but not limited to those concerning merchantability
and fitness for a particular purpose. Because of the difficulty in
ascertaining and measuring damages hereunder, it is agreed
that Seller’s liability to the Buyer shall not exceed the total
amount billed and billable to the Buyer for the product
hereunder.
KEEP OUT OF REACH OF CHILDREN
WARNING: INJURIOUS TO EYES
Shelf Life Best when used within one year in
original, unopened bags
Storage Conditions Store dry, cool, out of direct sunlight.
Best to condition material to 50-80°F
(10°-27°C) before using.
Color
Gray
Brush on Applied
Trowel on Applied
Akona
®
is a registered trademark of TCC Materials
2025 Centre Pointe Blvd., Suite 300
Mendota Heights, MN 55120 USA
www.tccmaterials.com
© Copyright 2019 TCC Materials
REV 06.19