Installation Instructions

T E C H M I X

PREIMUM CONCRETE COUNTER TOP MIX

™

10■ Remove the plastic from the countertop surface and remove all the screws holding the form

together. The countertop will still be very fragile so use care in removing forms. If necessary, use

small wooded shims to help remove the sides of the form. Put down some small pieces of foam

next to the base of the form. Then hold the base of the form and the countertop, lift the countertop

onto the foam in a vertical position. Gently remove the bottom of the base.

11■ Gently remove any cut outs. Using caution lay the top down on foam scraps with the surface

of the countertop up. Using a sanding block smooth all the edges and remove any imperfections/

defects. The surface of the countertop can be wet polished or cleaned and sealed, as is, depending

on the desired appearance. Follow all instructions for the sealing products used. If pinholes are

present use a non sanded patch to fill any pinholes or to touch up any imperfections or defects

along the edges prior to finishing.