Installation Instructions

7■ Fill the countertop form with the mixture making sure it fills in around any reinforcement and

around all cutouts. Knead the material with your hands to assure the material is evenly spread

throughout the mold and to begin elimination of air holes. Gloves should be worn for this process.

T E C H M I X

PREIMUM CONCRETE COUNTER TOP MIX

™

8■ Vibrate the form by tapping with a rubber mallet around all the edges or by using a palm sander

without any paper on it. This is an important step to minimize pinholes in the countertop surface.

Screed of any excess material with a 2x4.

9■ After the material in the form has begun to take a set, normally 1 hour, snip off the wire ties

holding the wire mesh just below the surface of the countertop mix. If needed, screed the back off,

using a 2” x 4” moving it in a sawing type movement against the top of the side forms. Cover the

countertop mix with plastic and allow it to cure 18-24 hours.