Datasheet

Inhalation : Remove from exposure and move to fresh air immediately, If not breathing, give
artificial respiration. If breathing is difficult, give oxygen. Get medical attention.
General Information : As in any fore, wear a self-contained breathing apparatus in
pressure-demand, MSHA/NIOSH ( approved or equivalent), and full protective gear.
Substance can explode when wet and heated with magnesium.
Extinguishing Media : Use water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
General Information : Use proper personal protective equipment as indicated in Section 8.
Spills/Leaks: Vacuum or sweep up material and place into a suitable disposal container.
Avoid dust formation. Provide ventilation. Pellets remained on ground may cause slipping.
Handing : Use with adequate ventilation, Do not breathe dust, vapor, mist, or gas.
Avoid prolonged or repeated contact with skin. Avoid contact with eyes.
Avoid ingestion and inhalation.
Storage : Store in a tightly closed container. Store in a cool, dry, well-ventilated area
away from incompatible substances.
Engineering Controls : Facilities storing or utilizing this material should be equipped
with an eyewash facility and a safety shower. Use adequate ventilation to keep airborne
concentrations low.
Personal Protective Equipment
Eyes : Wear appropriate chemical safety goggles.
Skin : For prolonged or repeated contact use protective gloves.
Clothing : Normal work wear.
Respirators : Follow the OSHA respirator regulations found in 29 CFR 1910.134 or
European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149
approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.
Physical State : Granules
Color : Colorless
Odor : Odorless
pH : 3-8
Vapor Pressure : Not applicable
Boiling Point : ﹥2300 ℃
Section 6 - Accidental Release Measures
Section 7 - Handling and Storage
Section 8 - Exposure Controls, Personal Protection
Section 9 - Physical and Chemical Properties
Section 5 - Fire Fighting Measures
Dust tight:
According to DIN 55473 Type A