Installation Guide



CLIPONSUPERCORNERS™

INSTALLATIONGUIDE



Manufactured&Marketedby:



TheJARMALOWCOMPANY,LLC

218FederalHillRoad

Hollis,NH03049



PAGE 1
CLIPON SUPERCORNERS ™ INSTALLATION GUIDE Manufactured & Marketed by: The JARMALOW COMPANY, LLC 218 Federal Hill Road Hollis, NH 03049
PAGE 2
INSTALLATION GUIDE Step 1: Cut to Length: ™ to size. Measure the height of the corner and cut the ClipOn SuperCorner Step 2: Slide one side of the ClipOn SuperCorner into one of the JChannels on the existing small corner as shown below. Step 3: (Optional) Cut a small V out of the ClipOn SuperCorners™ every 23 feet with sheer scissors, As shown below. This will make for easier installation.
PAGE 3
Step 4: Grab the lip of the other ClipOn SuperCorner™ fold and lift it over the edge of the opposite J Channel until it snaps into place. Repeat over and over until the both sides of the ClipOn SuperCorner ™ is fit tightly onto the the smaller vinyl corner. Step 5: Adjust the ClipOn SuperCorners™ as needed. Step 6: Screw one small setting screw at the bottom or top of the ClipOn SuperCorners™. Choose as side less visible from the front. (Screw not included.