Instructions / Assembly

Step 3
Install the Back Leg (C) into the bottom of the Chair Base(A) by placing the
Plastic Washer (①) and Rubber Washer (②) onto the threaded stem.
And then insert the threaded Stem into the threaded Mounting Position at
each Corner of the Bottom of the Chair Base (A).
Tighten by turning the Legs clockwise.
Repeat the same steps to install the three remaining legs.
Note:The use of Plastic Washer (①) and Rubber Washer (②) are
OPTIONAL and is especially useful to help alleviate slight
wobbleness.Some legs may need more than one Plastic Washer (①) and
Rubber Washer (②) whilst some legs may not need any.
Your LOVESEAT is ready for use.
Your LOVESEAT can only be used on a flat, level surface.
Step 4
Chair Base (A)
Rubber Washer(
②
)
Front Leg (B)
Back Leg (C)
Plastic Washer(
①
)
Front Leg (B)
Noble house Home Furnishings LLC
4 of 5