Instructions / Assembly

- 12 -
5. Shaping the Tree Branches
You can shape the tree branches working with each row individually, and
working your way from the inner tips outward on each branch. Shape the tips to
fill gaps between branches to make the tree full and natural looking.
(Figure 11)
6. Helpful Hints
The following helpful instructions should assist you with common questions that
many people have.
Where to find the model number of your tree?
It is important to keep record of your model number in order for customer service
to assist you with any type of warranty question or claim.
The model number can be found on the short side of the box. It may also be
found on a sticker located on the pole of the very bottom section going into the
stand.
How to replace burnt bulbs?
Any burnt bulbs will have a black or silvery ring around them. We recommend
checking for burnt out bulbs each year during set-up and take down of your tree.
If one bulb burns out, the rest will remain lit, however, as soon as a bulb burns
out, it should be replaced immediately. This will extend the life of the remaining
working bulbs.
Leaving burnt out bulbs in the light set after a long period of time, will cause a
domino effect on the working bulbs. You might even notice the light set burning
much brighter. Eventually, all 50 bulbs in the same ring will burn out in and will
need to be replaced.
Please note that burnt out bulbs are not covered
under the warranty. They are considered normal wear
and tear and not a warranty defect.
(Figure 12)
Replacing burnt bulbs