Installation Guide

UPGRADED INSTALLATION INSTRUCTION

(use enclosed finishing nails instead of sticky foam)

1. Select orientation: horizontal, vertical

or diagonal.

2. Using a level draw a line on a wall for

the Starter Plank.

3. Prepare finishing nails: either install

enclosed nail strip in to the nail gun

for 1.25” # 18 gage brad nails, or chip

nails from the strip for hummer

installation.

4. Apply a whole length or pre-cut

starter plank to the line on the wall

and fix it with the nails in each corner

of the plank. Step at least 1 in. from

each side or end of the plank to nail it.

For long planks apply two more nails

in the middle of the board.

5. If you need to cut planks use any

wood saw (table saw or hand saw) or

cut the furrow in the wood with a

utility knife on both sides of the plank

and break it against the edge of the

table.

6. If you need to attach wall art or

shelves on top of the wall planks, drill

the holes and put hangers through

the planks on your wall. Don’t hanger

anything heavier than 0.5 lbs on the

planks themselves!

7. Other installation options:

- Double sided sticky foam – don’t recommend

using them alone (sooner or later planks may

fall down) if you not secure planks with nails.

- Adhesive or liquid nails – recommended if you

use a contractor for professional installation.

The adhesive should be applied along the

length of the planks with three thin strips (not

as butter on brad distributed evenly (!)):

PAGE 1
UPGRADED INSTALLATION INSTRUCTION (use enclosed finishing nails instead of sticky foam) 1. Select orientation: horizontal, vertical or diagonal. 2. Using a level draw a line on a wall for the Starter Plank. 3. Prepare finishing nails: either install enclosed nail strip in to the nail gun for 1.25” # 18 gage brad nails, or chip nails from the strip for hummer installation. 4. Apply a whole length or pre-cut starter plank to the line on the wall and fix it with the nails in each corner of the plank.