Datasheet

ManualsBrandsUnbranded ManualsLEDs & AccessoriesLED wired Red, White Circular 5 mm 950 mcd, 2000 mcd 30 °, 18 ° 20 mA, 20 mA 2 V, 3.3 V

2.54

1.0 (min.)

1.0

White anode

Red anode

8.9

15.0 (min.)

5.0

5.5

ø5mm bi-color LED (Non-polarity)

YBR-50FRW00

Distributed by Conrad Electronic SE

Features:

1) Chip Material: AlGaInP & InGaN

2) Lens Color: Water Clear

3) Source Color: Red & White

4) Pb free

5) The product itself will remain within RoHS compliant version.

Dimensions:

Notes:

The tolerance is ±0.25mm.

Summary of content (5 pages)

PAGE 1
® ø5mm bi-color LED (Non-polarity) YBR-50FRW00 Features: 1) 2) 3) 4) 5) Chip Material: AlGaInP & InGaN Lens Color: Water Clear Source Color: Red & White Pb free The product itself will remain within RoHS compliant version. Dimensions: 5.5 15.0 (min.) 8.9 5.0 White anode 2.54 1.0 Red anode 1.0 (min.) Notes: The tolerance is ±0.25mm.
PAGE 2
® ø5mm bi-color LED (Non-polarity) YBR-50FRW00 Absolute Maximum Ratings at Ta=25℃: ( Red ) Parameter Power Dissipation Peak Forward Current (Duty 1/10 @ 1KHz) Symbol Pd Maximum 70 Unit mW I FP 40-100 mA Forward Current IF 20 mA Reverse Voltage VR 5 Operating Temperature Range Storage Temperature Range Lead Soldering Temperature [2.0mm from body] Topr Tstg Tsol V ℃ ℃ -25 to +80 -40℃ to +100℃ Reflow Soldering: 260℃ for 10 sec. Hand Soldering: 350℃ for 3 sec.
PAGE 3
® ø5mm bi-color LED (Non-polarity) YBR-50FRW00 Absolute Maximum Ratings at Ta=25℃: ( White ) Parameter Power Dissipation Peak Forward Current (Duty 1/10 @ 1KHz) Forward Current Electrostatic Discharge (HBM) Reverse Voltage Operating Temperature Range Storage Temperature Range Lead Soldering Temperature [2.0mm from body] Symbol Pd Maximum 100 Unit mW I FP 120 mA IF ESD VR 30 2000 5 mA V V Topr Tstg Tsol -25 ℃ to +80℃ -40℃ to +100℃ Reflow Soldering: 260℃ for 10 sec.
PAGE 4
® ø5mm bi-color LED (Non-polarity) YBR-50FRW00 Reliability test items and conditions: The reliability of products shall be satisfied with items listed below.
PAGE 5
® YBR-50FRW00 ø5mm bi-color LED (Non-polarity) Precautions: TAKE NOTE OF THE FOLLOWING IN USE OF LED 1) Temperature in use Since the light generated inside the LED needs to be emitted to outside efficiently, a resin with hight light transparency is used; therefore, additives to improve the heat resistance or moisture resistance (silica gel, etc) which are used for semiconductor products such as transistors cannot be added to the resin.