ALL PURPOSE CANOPY 20' x 20' x 9'6" (6.1 x 6.1 x 2.9 m) ASSEMBLY MANUAL Model NO.
TABLE OF CONTENTS Important safety instructions...................................................................................................................................................................................... 2 Intended use ............................................................................................................................................................................................................ 2 Parts list .................................................
PARTS LIST Drawing Qty. Part# Description 1 77.5” x 2” Pipe 16 2 77.5” x 1 1/2” Pipe 9 3 50” Swedge pipe 8 4 3-way connectors 6 5 4-way connectors 6 6 Ball tie downs 56 7 Foot pads 8 8 1 Green/White PE Cover with Leg Skirts ASSEMBLY PREPARATION ● ● ● Place all parts from the packaging box in a cleared area and arrange them on the ground in front of you. Remove all packaging materials and place them back in the box.
ASSEMBLY Step 1 ● Lay out the roof frame parts as shown below. ● Please note: The Parts #2 are used to form the side and peak. The parts #1&3 are used to form the roof rafter. 3 1 4 3 4 1 4 2 2 5 3 1 2 3 5 2 1 5 2 5 3 1 2 3 5 2 5 1 2 2 3 3 1 4 1 4 4 ● Start with the center and complete the center frame first,. Then assemble each side.
ASSEMBLY Step 2 ● Connect 4 legs of one side to the 4-way and 3-way connectors. 1 1 1 1 Step 3 ● Unfold the cover with the grommets toward the cover's bottom and place the cover over the frame. The flared edges should be located at each of the 4 corners of the frame.
ASSEMBLY Step 4 ● Connect the 4 legs for the other side the same way. And then attach the cover to the frame with ball tie downs. ● To properly install a bungee and starting at the four corners of the cover: Insert the ball tie down into the eyelets and wrap the cord around the tube and hook it over the ball. 6 Step 5 ● Insert the eight legs into the foot pads. And then attach the S-hook of the leg skirt to the foot pads.
ASSEMBLY Step 5 This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely anchored to the ground to prevent damage from winds. ● Screw each anchor into the ground leaving 2in between the ground and the eye of each anchor. ● Tie anchor cable or rope around the connector at the top of each leg of the canopy. ● Securely tie the other end of the cable or rope through the eye of the anchor and pull tight.
IMPORTANT NOTICE IMPORTANT NOTICE: PLEASE READ CAREFULLY PRECAUTIONS WHICH MUST BE FOLLOWED: Keep all flame and heat sources away from this tent fabric. The tent fabric will burn if left in continuous contact with any flame source. DO NOT cook underneath or near canopy. DO NOT store or use flammable liquids underneath or near canopy. DO NOT ignite or store fireworks underneath or near canopy. DO NOT use bleach to clean cover. DO NOT dry clean cover. DO NOT wash cover in washing machine or dry in dryer.
