Use and Care Guide

USER SERVICING INSTRUCTIONS

TO REPLACE THE FUSE:

1) Grasp plug and remove from the receptacle or other outlet

device. Do not unplug by pulling on cord.

2) Open fuse cover. Slide open fuse access cover on top of

attachment plug toward blades.

3) Remove fuse carefully. Turn plug over to remove fuse.

4) Risk of fire. Replace fuse only with 3 Amp, 125 volt fuse (provided with product).

5) Close fuse cover. Slide closed the fuse access cover on top of attachment plug.

6) Risk of fire. Do not replace attachment plug. Do not remove the safety device (fuse).

Discard product if the attachment plug is damaged.

REPLACING LAMPS FROM LAMP HOLDERS

1) Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.

2) Unlock the burned out LED lamp by lifting the hook and pull lamp and plastic base straight out of lamp

holder as shown in Fig. 1.

3) Insert the spare LED lamp into the lamp holder in correct direction and lock the hook of lamp base by

pushing lock down into the tab as shown in Fig. 2.

4) Replace lamp with only 3.4 volt, 0.068 watt LED type lamps provided with this product.

CAUTION:

a) Do not exchange the lamp base on the new lamp with the old one or the LED wires may break.

b) Pull lamp and plastic base straight out of lamp holder.

c) Do not deliberately change the direction of the LED lamp in the lamp holder (always match the hook to

the tab, see Fig. 2).

CAUTION:

This string is rated 4.8 watts (0.04 Amps); do not overload. Connect other lighting strings or decorative

outfits end-to-end up to a maximum of 216 watts (1.8 Amps) total.

If connecting to a lighting string that does not have a wattage rating (found on the tag within 6 inches of the

plug), calculate the wattage as follows: Multiply the current which is on the flag type label located within 6

inches of the plug by 120.

For example, string is rated 120 volts, 60 hertz, 0.02 Amps.

0.02 × 120 = 2.4 watts.

Total amount of wattage that can be connected is 216 watts – 2.4 watts = 213.6 watts.

CAUTION:

a) Risk of fire. This product does not contain lamp shunts, which allow the product to operate if one lamp

burns out. Do not replace lamps with other than the spare lamps provided with this product.

b) Replace lamps only with 3.4 volt, 0.068 watt spare lamps provided with this product.