Installation Guide
4
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
CAUTION:
a) Risk of fire. This product does not contain lamp shunts, which allow the product to operate if
one lamp burns out. Do not replace lamps with other than the spare lamps provided with this
product.
b) Replace lamps only with 4 volt, 0.24 watt spare lamps provided with this product.
USE AND CARE INSTRUCTIONS
When the product is placed on a live tree, keep the tree well-maintained, fresh, well-secured, and
stable. Do not place on live trees in which the needles are brown or break off easily. Keep the
tree holder filled with water.
Before using or reusing, inspect product carefully. Discard any products that have cut, damaged, or
frayed wire insulation or cords, cracks in the lamp holders or enclosures, loose connections, or
exposed copper wire.
When storing the product, carefully remove the product from wherever it is placed, including
trees, branches, or bushes, to avoid any undue strain or stress on the product conductors,
connections and wires.
Store neatly in a cool, dry location protected from sunlight.
The LED lamp has polarity. Do not deliberately change the direction of the LED lamp in the lamp
holder.
(A) This product is operated with remote control and has 72 lighting effects.
10 colors:
(1) Cool white (2) Red (3) Green (4) Blue (5) Yellow
(6) Purple (7) Aqua (8) Orange (9) Pink (10) warm white
7 effects:
(1) Steady on (2) Rhythm (3) Flashing (4) Chasing (5) Waving (6) Twinkling (7) Fading
2 color changing function:
(1) Color changing chasing (2) Color changing flashing
The remote controller has “ON”, “OFF”, “FUNCTIONS” and “SYNC”
(B) Helpful hints in synching:
The remote range is 30 meters when they are arranged in free open air without any
interference. All connected sets have to be placed in valid remote range, in order for all the
sets to sync simultaneously. All light strings work on the same frequency and should be
operable with one remote.
(a) If the sync button is not working correctly at first, try holding down the sync button for 5
seconds or more continuously in an effort to re-set it. Or let the sets work independently
for 5 – 10 minutes and then try pressing the SYNC button again. Sometimes the issue will
disappear after running for a long time.
(b) Check to ensure the battery is not exhausted, it is best to always use with new batteries.